DART CONTROLS 125 SERIES ANALOG SCR NEMA 4X DRIVE 125DV200EW-29

125DV200EW-29 DART Controls 125 Series Analog SCR NEMA 4X Drive is contained in a cast aluminum powder coated enclosure for wash down, outdoor, and food/sanitary applications. One drive will handle both 120VAC and 240VAC source power. Dart's standard auto-sensing voltage circuit means no jumper setting or wiring changes are necessary. The drives are fully adjustable across their HP ratings - no extra resistors to purchase or keep track of. Standard features include an inhibit circuit for start/stop operation and 1% speed regulation over a 50:1 speed range. Long life and quality are assured by 100% full load testing.

HP Rating:

• 1/8 - 1HP @ 120VAC
• 1/4 - 2HP @ 240VAC

Operator Controls:

• Pilot Light, Speed Pot, On/Off, FWD/STOP/REV

Features:

• +/-10% rated line voltage
• Adjustable horsepower settings
• Barrier terminal strip
• Full wave bridge supply
• 1% speed regulation
• Adjustable minimum speed (0-30% of base)
• Adjustable maximum speed (66-100% of base)
• Adjustable IR compensation
• Adjustable current limit
• Includes 4PDT center block (no pass) switch motor reversing. Cuts off power supply while changing motor direction.
• -10°C to +45°C ambient temperature
• Line voltage compensation
• 5K ohm speed potentiometer kit included
• 50:1 speed range
• Overload capacity: 200% for one minute
• Transient voltage protection
• Voltage follower mode - isolated signal (0-10VDC)
• Inhibit circuit - permits low power start and stop
• UL Listed