DART CONTROLS 130 SERIES ANALOG SCR CHASSIS DRIVE 130LC12

DART Controls 130 Series Analog SCR Drives are an economical, safe, and effective drive solution for applications which require rapid stopping (brake) or reversal of the motor being controlled. The 130 Series utilizes Dart’s unique zero-speed detect and solid state dynamic braking circuits. These circuits eliminate the contact arcing and failed braking problems associated with other reversing and dynamic braking controls. Dart’s zero-speed detect circuit also eliminates motor plug reversing problems. The 130 Series control comes in a compact package and fits the industry standard footprint for both vertical and horizontal mounting. In many applications, the 130 Series will replace expensive regenerative drives that do not require holding torque for the application. HP Rating: 1/50 - 1/8HP Cycles/Min: LOW (Up to 3 C/m) Features: Full HP rated - no auxiliary heat sink required +/-10% rated line voltage, 50/60Hz operation Adjustable horsepower settings Barrier terminal strip Full wave bridge supply; 1% speed regulation Adjustable minimum speed (0-30% of base) Adjustable maximum speed (60-100% of base) Adjustable I.R. Compensation Adjustable Current Limit -10°C to +45°C Ambient Temperature Line voltage compensation 5K ohm speed potentiometer kit included 50:1 speed range Overload capacity: 200% for one minute Transient voltage protection Voltage follower mode - isolate signal (0-10VDC) Inhibit circuit - permits low power start and stop Automatic dynamic brake on power loss Available in chassis models only Applications: Door operators, feeders, tapping machines, spray/brush applicators, screen presses, powered drawer operators, target operators, antennae operators